K&N 1996-99 Mustang COBRA Only Generation II Air Intake Kit
K&N 1996-99 Mustang 4.6L Cobra Generation II Air Intake Kit
These break-through engineering designs contain all the performance improvements you expect from K&N, but with even greater benefits. What is truly remarkable about the Generation II kits is that they consistently achieve incredible horsepower gains even under varying atmospheric conditions. This process is accomplished by replacing the entire air intake tract, thus isolating the cold air and directing the air through this truly unique chamber delivery system. This process may or may not include a heat shield.
Filter Cleaning Kit Included! Filters Air More Effectively Than A Stock Paper Element! Allows More Air into Engine! Easy Bolt-On Installation! Million Mile Limited Warranty! HP & Torque: 14-16 HP/22 lb ft Torque
Installation: Designed to Replace the Restrictive Factory Air Filter Housing. This is a BOLT-ON Kit. Installation Normally Takes 20-30 Minutes and Includes All the Necessary Hardware. Only Regular Hand Tools Required. Comes With Complete Instructions.
Tech Notes: Filter is cleaned by first brushing off any large embedded dirt. Then spray on the K&N cleaner and let it soak for 10 minutes. Next, Rinse off the element with LOW pressure water. (Always flush from the clean side to the dirty side.) Then allow filter to dry NATURALLY. After filter has dried re-oil with K&N air filter oil only. Apply evenly to entire filter making sure to oil down into each pleat. Then re-install making sure the element seats properly in the filter case. 50 States Smog Legal
